THOMSON Scenium DPL900VD User Manual

Connection described below is also applicable for any component having digital output (TV, Cable & Satellite boxes, MD, CD recorder/player) NOTE: • By default, SAT is set to use analog input. • After the connections are done, check the receiver and make sure it
is set to the appropriate digital/analog input by pressing the DIGITAL button on the remote control. The input will be displayed after the source name . (SAT/OPTI means SAT uses Optical Input) • To change input connection, follow step 3 in “Digital Connection” described below. • If a COAXIAL cable is used to
connect SAT to the receiver, follow steps 3 in “Digital Connection” to select COAXIAL. • S-Video connection provides better quality than composite connection. If S-Video is used on your DVD receiver (SAT IN), MON OUT S-Video should also be used, otherwise, no picture will be displayed on TV.
Satellite & Digital Connections
Speakers • Match the speaker cable color to the speaker / receiver terminals as shown on the illustration. • Match the speaker to the correct terminal on the receiver (example: left speaker to left speaker terminal on receiver)
NOTE: • The color of the cable should be the same as that on the terminals. • Connect the striped color cable to the “-” terminal (both speaker and receiver)
For details, please refer to Instruction manual chapter “Connecting the Speakers” (Pg. 6)
Follow the illustration and instructions provided to hook up your speakers.
Speakers and Tuner Antenna
RCA Audio cable
(Analog)
Not Included
Composite Video
Cable (Usually
yellow)
1Piece
S-Video cable
Not Included
Optical Cable
(Digital)
Not Included
Coaxial Cable
(75Ω / Digital)
Not Included
SCART Cable
1Piece
Audio/Video components
Follow the diagram to connect audio or video components.
Follow the diagram to connect your Satellite box to receiver.
Antenna and Speaker
Wire Connection
Push Speaker terminal tab down to insert wire.
Release tab to lock wire in the terminal. NOTE: Make sure the insulation is completely removed from the ends of the Antenna and
speaker wires at all connection
points.
ANTENNA HOOKUP
SPEAKER HOOKUP
Cables To help you identify the cables used in audio-video, illustrations are provided below for your easy reference.
To OPTICAL IN of MD / DVD / CD recorder.
A Connecting your Satellite 1
Connect the RCA Audio cable.
2 Connect the video cable
(composite or s-video)
B Digital Connections To receive Dolby Digital format or any digital signal, either a coaxial or optical cable must be connected. Follow the steps below for digital connection. 1 Connect either the
COAXIAL or OPTICAL cable (not included)
2 Select SAT 3 Press DIGITAL
button several times on the remote control to select the input being used (analog, coaxial, or optical)
Connection described below is also applicable for any component having analog output (TV, Cable & Satellite boxes, CD recorder/player,)
MADE IN CHINA
DIGITAL AUDIO
COAXIAL
IN
OPTICAL
IN
SAT
OPT
OU
BLUE / BLACK
BROWN / BLACK
RED / BLACK RED / BLACK
GREY / BLACK
GREY / BLACK
CENTER SPEAKER
CENTER SUB
FRONT
REAR
LR LR
SPEAKERS
REAR SPEAKER
SUBWOOFER
REAR SPEAKER
1
1
1
2
2
CENTER SUB
FRONT
REAR
LR LR
AM LOOP
FM 75‰
Manufactured under licence from Dolby Laboratories. "Dolby", "Pro Logic 2" and the double-D symbol are trademarks of Dolby Laboratories. Confidential Unpublished Works. ' 1992-1997 Dolby Laboratories, Inc. All rights reserved.
SPEAKERS
AUDIO
DIGITAL AUDIO
VIDEO
VCR IN
VCR OUT
L
IN OUT
R
VCR
COAXIAL
IN
OPTICAL
IN
SAT
OPTICAL
OUT
SAT
IN
SAT
IN
ME67
TV
POWER SOURCE: 230V 50Hz RATED INPUT POWER: 300W SECTEUR 230V 50Hz CONSOMMATION NOMINALE: 300VA
Shock hazard - do not open! Keep dry! Before opening disconnect power plug! Risque de choc lectrique ne pas ouvrir! Vor ffnen Netzstecker ziehen! Vor Feuchtigkeit schtzen! Przed otwarciem obudowy wyjàç wtyczk´ z gniazda sieciowego
Attention: Attention: Achtung: UWAGA:
230V 50Hz
MON
OUT
TV
SAT/ CAB
VIDEO/
VCR
ok
3
2
AM LOOP
FM 75
Ω
White
GND
FRONT SPEAKER
FRONT SPEAKER
SAT
OUT
AUDIO
VIDEO
OPTICAL
OUT
S-VIDEO OUT
(If available)
COAXIAL
OUT
THOMSON MULTIMEDIA INC. MANAGER CONSUMER RELATIONS, P.O. BOX 1976, INDIANAPOLIS, IN46206 MADE IN CHINA
O
DIGITAL AUDIO
T
COAXIAL
IN
OPTICAL
IN
SAT
OPTICA
OUT
SAT
IN
A INC.
R RELATIONS,
APOLIS, IN46206
L AUDIO
VIDEO
VCR
OUT
MON
OUT
OPTICAL
IN
OPTICAL
OUT
SAT
IN
DIGITAL (if available)
OUT
GND
CENTER SUB
FRONT
REAR
LR LR
AM LOOP
FM 75Ω
230V 50Hz
Manufactured under licence from Dolby Laboratories. "Dolby", "Pro Logic 2" and the double-D symbol are trademarks of Dolby Laboratories. Confidential Unpublished Works. © 1992-1997 Dolby Laboratories, Inc. All rights reserved.
SPEAKERS
AUDIO
DIGITAL AUDIO
VIDEO
VCR IN
VCR OUT
L
IN OUT
R
VCR
COAXIAL
IN
OPTICAL
IN
SAT
OPTICAL
OUT
SAT
IN
SAT
IN
ME67
TV
MON
OUT
TV
2-1997 Dolby Laboratories,
POWER SOURCE: 120V 60Hz POWER CONUMPTION: 300W REFER INQUIRIES TO: THOMSON MULTIMEDIA INC. MANAGER CONSUMER RELATIONS, P.O. BOX 1976, INDIANAPOLIS, IN46206 MADE IN CHINA
DIO
DIGITAL AUDIO
VIDEO
VCR
OUT
MON
OUT
OUT
COAXIAL
IN
OPTICAL
IN
SAT
OPTICA
L
OUT
SAT
IN
SAT
IN
1
ton is
y not
pt any
se
Manufactured under licence from Dolby Laboratories. "Dolby", "Pro Logic 2" and the double-D symbol are trademarks of Dolby Laboratories. Confidential Unpublished Works. © 1992-1997 Dolby Laboratories, Inc. All rights reserved.
AUDIO VIDEO RECEIV POWER SOURCE: 120V 60H POWER CONUMPTION: 300W REFER INQUIRIES TO: THOMSON MULTIMEDIA INC. MANAGER CONSUMER RELA P.O. BOX 1976, INDIANAPOLIS MADE IN CHINA
A UDIO
DIGITAL A
L
IN OUT
R
VCR
COAXIAL
IN
OPTIC
IN
SAT
SAT
IN
VCR
IN
OUT
AUDIO
VIDEO
VIDEO
VCR IN
VCR OUT
MON
OUT
SAT
IN
IN
OUT
Video In
S-Video In
Video In/Out

THOMSON Scenium DPL900VD Specifications

General

Brand	THOMSON
Model	Scenium DPL900VD
Category	Home Theater System
Language	English