THOMSON THVC2318 - Page 30

Tips: Choose location close to power outlet. Locate point high enough on
wall to allow wand and power brush to hand freely. Place wall mount against
wall and use pencil to mark drill holes. Drill holes (with 1/4”bit) and insert
drywall anchors. Insert screws through holes on mount and tighten until
firmly attached.
Drywall
anchors
0
Screws
- Slide wand into main body until it clicks.
- Push wand into power brush until it clicks.
- Accessories can be connected with wand when cleaning high position.
How to connect accessories?
ds
S
ij
EN-8