THOMSON TRMC50.4X - OVEN OPERATION AND PROGRAMMING; Programmer, Timer, and Automatic Modes

0000
OK
19
0000
OK
OPERATION
Electronic programmer
Setting the time
After connection to the mains or reconnection
after a power cut the display shows ash 0.00.
Timer
The timer can be activated at any time, re-
gardless of the status of other functions. The
timer can be set for from 1 minute to up to 23
hours and 59 minutes.
To set the timer you should:
Press button OK, then the display will show
ashing ,
Press button OK, then the display will show
,
set the time using buttons < / >.
7 seconds after the time has been set the
new data will be saved.
To modify the time setting, simultaneously
press < and > to make the time ash on the
screen. You will then be able to correct the
time setting using < and > buttons.
Caution!
If the correct time is not set then proper opera-
tion of the oven is not possible.
The electronic prgrammer is equipped with
electronic sensors which are switched on by
touching or pressing the sensor surface for at
least one second.
Each sensor reaction is conrmed by the beep.
Keep the sensor surface clean at all times.
set the timer using buttons < / >.
The time set is shown on the display and the
signal function is on.
Press button OK , < or > in order to switch
off the signal, the signal function will go out
and the display will show the current time.
Caution!
If the alarm signal is not turned off manually,
it will be turned off automatically after approx.
7 minutes.
OK - function selection sensor
< - button „-”
> - button „+”
- functions
Downloaded from www.vandenborre.be