THOMSON WMP 540 - User Manual

Before you begin, ensure that the rated voltage of the AC/DC power
adapter is the same as the mains power.
1. Connect the AC/DC power adapter to the mains power supply outlet.
Insert the DC connector of the AC/DC power adapter into the 12 Volt
DC input located at the rear of the receiver.
2. Connect the microphone output located at the rear of the receiver to
the microphone input of your hi-fi or karaoke system using the audio
cable.
3. Open the microphone unit and install the 9 Volt battery into the battery
compartment.
4. Select the channel.When using only one microphone set, ensure that
channel A is selected on the receiver. When using two microphone sets
in the same room at the same time, switch the second microphone set
to channel B.
SET-UP
When closing the microphone unit, ensure not to damage the antenna.
MIC OUT
CHANNEL
A B
TUNING
DC IN
12 V
Congratulations! You have bought a most sophisticated wireless micro-
phone system. Easy to connect to a hi-fi or karaoke system, this micro-
phone uses a high radio frequency as the signal carrier, ensuring a very
clear, sharp reception. It also uses 360°signal technology to give you total
freedom of movement. You can operate two microphone systems simulta-
neously in the same room.
GB
wmp540 9/11/00 9:35 Page 1

Summary

Setting Up Your Wireless Microphone System

Connect Power Adapter

Connect the AC/DC power adapter to the mains outlet and the 12 Volt DC input on the receiver.

Connect Audio Cable

Connect the microphone output from the receiver to your hi-fi or karaoke system's audio input.

Install Microphone Battery

Open the microphone unit and install a 9 Volt battery into the compartment.

Select Microphone Channel

Select channel A for one microphone set, or channel B for a second set in the same room.

Product Controls

Microphone Controls

Overview of microphone controls: power switch, tuning knob, and power/battery LED.

Receiver Controls

Overview of receiver controls: tuning knob, micro output, power input, channel switch, and power indicator.

Operating the System

Power On Procedure

Switch on the power and check the power-on LED indicator.

Channel Selection for Operation

Ensure correct channel (A or B) is selected on the receiver for one or two microphone sets.

Fine-Tuning the Signal

Speak into the microphone and use tuning controls on receiver and microphone for optimal signal.

Adjusting System Volume

Adjust the volume on your connected hi-fi or karaoke system.

Product Specifications

Technical Specifications Summary

Details on wireless microphone system, receiver power, microphone power, frequency, range, and sensitivity.

THOMSON WMP 540 Specifications

General

Brand	THOMSON
Model	WMP 540
Category	Microphone system
Language	English