THOMSON WMP 540 - Product Controls; Microphone Controls; Receiver Controls; Operating the System

1. Switch the power switch on ON. The power-on LED lights up.
If the LED does not light up, the battery is empty and should be replaced.
2. When using only one microphone set, ensure that channel A is selected
on the receiver. When using two microphone sets in the same room at the
same time, switch the second microphone set to channel B.
3. Speak into the microphone. Fine tune the signal using the tuning controls
on the receiver and the microphone.
4. Adjust the volume on your hi-fi or karaoke system.
OPERATION
SPECIFICATIONS
Wireless microphone
Receiver power supply: 12 Volt mains adapter
Microphone power supply: 9 Volt SM544 6LR61 battery, non rechargeable
High frequency radio system 433 MHz
Operating range: up to 30 m
2 channels
Frequency range: 80 - 16 000 Hz
Sensitivity: 55 dB
Signal noise ratio: > 60 dB
FM subcarrier frequencies: channel A: 434.4 to 434.7 MHz, channel B: 433,2 to 433,5 MHz
Please respect the environment and prevailing regulations.
Before you dispose of batteries or accumulators, ask your dealer whether they are subject
to special recycling and if he accepts to take them back.
CONTROLS
Microphone: Receiver:
power on switch tuning knob
tuning knob micro output
power on and battery LED power adapter input (DC IN 12 V)
channel selection switch
power on indicator
GB
wmp540 9/11/00 9:35 Page 2