Installation
11
■ Sink siphon
Secure the drain hose to the sink siphon using a
Ǿ 0.9-1.6 in.(20-44mm) hose clip (available from a
hardware store).
Wash Basin
WARNING
SCALDING
When washing at high temperatures, there is a risk
of scalding if you touch hot suds, e.g. when
pumping out hot suds into a wash basin.
Do not reach into the hot suds.
Notice: Appliance damage/ damage to textiles
If the end of the drain hose touches the discharged
water (water drained from washer), it (the
discharged water) can be sucked back into the
washer and may damage the appliance or textiles.
Make sure that:
There is no stopper in the sink drain.
The end of the drain hose does touch the
discharge water.
The sink drain is free flowing and not partially
clogged.
Attach the drain hose securely to the wash basin.
1 Do not twist, pull out or bend the drain hose.
1 Secure the drain hose with the cable tie to the
drain pipe, wash basin, etc., so the hose does not
pull out from the force of the water.
1 We advise against the use of drain hose
extensions; in case of absolute need, the extension
must have the same diameter as the original hose
and must not exceed 250cms in length.
To Next Page
Loading...
