Safety instructions
4
ELECTRICAL WARNING
1 It must be possible to disconnect the appliance
from the power supply by unplugging it if plug is
accessible, or by a multi-pole switch installed
upstream of the socket in accordance with the
wiring rules and the appliance must be earthed in
conformity with national electrical safety standards.
1When the appliance is installed, the mains
socket must be within easy reach.
1 When heating, the maximum current of the
appliance is 10A, so please make sure that the
power supply system (voltage, current and the cable)
is applicable to the load of the applied appliance.
1 In order to ensure your safety, you must plug the
cable into a socket which connected to earth. And
please check your socket to make sure that it is
connected with reliable earth correctly.
1 Do not use extension leads, multiple sockets or
adapters.
1The electrical components must not be accessible
to the user after installation.
1Do not operate the appliance when you are wet or
barefoot.
1Do not operate the appliance if it has a damaged
power cable or plug, if it is not working properly, or
if it has been damaged or dropped.
1 If the supply cord is damaged, it must be replaced
with an identical one by the manufacturer, its
service agent or similarly qualified persons in order
to avoid a hazard – risk of electric shock.
1Disconnect the power cord by grasping the plug,
not the cord.
CLEANING AND MAINTENANCE
1 WARNING! Ensure that the appliance is switched
off and disconnected from the power supply and
turn off the water tap before performing any
maintenance operation; never use steam cleaning
equipment – risk of electric shock.
1 Use caution when draining hot water from the
drum such as during pump maintenance.
SERVICE
1 Do not repair or replace any part of the appliance
or attempt any service unless specifically stated in
the user manual. Use only authorized After-sales
Service. Self or non-professional repair may lead to
dangerous incident resulting in live or health
threatening and/or significant property damage.
1 In the event of fault and/or malfunction, turn off
the appliance, close the water tap and do not
tamper with the machine. Immediately contact the
Customer Service Centre and only use original spare
parts. Failure to observe these instructions may
jeopardise appliance safety.
1 Certain internal parts are intentionally not
grounded and may present a risk of electric shock
during servicing. Service personnel – Do not contact
the following parts while the appliance is energized:
inlet valve(s), drain pump, heat sink of the motor
controller, PCBs.
1 Always unplug the appliance from the power
supply before attempting any service. Disconnect
the power cord by grasping the plug, not the cord.
1 Before the appliance is removed from service or
discarded, remove the door to prevent children
from playing or hiding inside. Also remove the
power cord/plug.
To Next Page
Loading...
