Setup and calibration
For best results when setting up your system, take your normal listening
position and have another person perform the following adjustments.
Since every room has different acoustics, it will take a bit of trial-and-error to
get your subwoofer sounding its best.
First set the Thor to either Theatre or Music mode (with the THEATRE/MUSIC
switch) depending on which you will use most often.
Set the subwoofer volume dial to the minimum position. Set the frequency
dial to 35Hz. Set any loudness, bass and treble controls on other equipment to
a neutral position (Loudness OFF).
Play a music track or video you are familiar with.
Gradually turn the subwoofer volume up until its deep bass blends well with
your main/satellite speakers.
Slowly turn the subwoofer frequency control up to reach the best mid-bass
blend with your main/satellite speakers. The smaller your main speakers, the
higher this will usually be. If the bass becomes boomy or ill-defined, you have
gone too far and should turn the Frequency Control down until the sound
regains balance.
Adjust the Phase switch so the best bass is achieved. This switch compensates
for relative distances between subwoofer, listener, other speakers and room
acoustics.
P
R
O
U
D
L
Y
A
U
S
T
R
A
L
I
A
N
S
I
N
C
E
1
9
8
6
61 2 4962 1594
info@richter.com.au
www.richter.com.au
Richter Acoustics Pty Ltd
PO Box 578
Hamilton NSW
Australia 2303
To Previous Page
Loading...