6
Before Using for the First Time
1. Carefully unpack the Theater Popcorn Maker and remove all packaging materials.
2. Clean measuring cap, oil spoon, pop-corn scoop and kettle with a clean damp cloth and dry
thoroughly.
3. Place the Theater Popcorn Maker on a clean, flat, heat-resistant working surface. Assemble the kettle
as explained in Assembly Instructions.
CAUTION: During popping, the unit gets hot. Make sure the surface is able to withstand heat or use
a trivet to protect the working surface.
4. Wipe the housing with a clean, damp cloth and dry thoroughly.
5. Connect the electrical cord between the popping kettle and the main unit first, and then connect
the main power cord into a wall outlet.
6. The Theater Popcorn Maker is now ready for use.
Assembly Instructions
Step 1 Step 2 Step 3
Step 4 Step 5 Step 6
Step 1: Assemble the kettle lid and stirrer by rotating the stirrer clockwise against the motor.
Step 2: Hang the kettle as shown and insert lock pin into hanger to secure it. After inserting lock
pin swing opposite end upwards to latch in the trigger switch mechanism.
Step 3: Plug the kettle power cord to the outlet as shown.
Step 4: Make sure door and foldable panels are in place.
Step 5: Lift the kettle lid to load kernels & oil to the kettle. Lower the kettle by tilting it down will
offer more room to work with. Make sure to close the lid and secure kettle in place by using
the kettle handle. Turn on the unit by using the on/off switch at the side.
Step 6: Once popping is completed, turn off the unit. Lift the kettle lid all the way to the top to
stick to the magnet. Close the door and use the trigger switch to release all the popcorn to
the chamber.
To Next Page
Loading...