Thrustmaster T128 - Pedal Set Configuration; Pedal Set Mode Explanation (Position & Type)

14/24
MODE FOR PEDAL SET
(Displayed each time the racing wheel restarts)
Each time the racing wheel restarts (and after its self-calibration), the 4 RPM LEDs (7) indicate the
mode (position and type) in which your pedal set is configured.
Position:
• NORMAL: default position;
• or INVERTED: in this position, the accelerator and clutch pedals are inverted — this position is only
possible with a 3-pedal pedal set.
Type:
• T2PM-T3PA-T3PM without Load Cell technology: default type;
• or T-LCM with Load Cell technology.
MODE FOR PEDAL SET FLASHING OF RPM LEDs (7)
DEFAULT MODE
- NORMAL position
- T2PM-T3PA-T3PM type
DEFAULT MODE
- NORMAL position
- T-LCM type
- INVERTED position
- T2PM-T3PA-T3PM type
- INVERTED position
- T-LCM type