Thrustmaster T128 - Inverting 3-Pedal Accelerator;Clutch Position

16/24
INVERTING THE POSITION OF THE PEDALS
(If you are using a 3-pedal pedal set)
The T128 racing wheel comes bundled with the 2-pedal T2PM pedal set by default. This racing wheel
is also compatible with the Thrustmaster T3PA, T3PM and T-LCM 3-pedal pedal sets (sold separately).
If you are using a 3-pedal pedal set, it is possible to electronically invert the accelerator and clutch
pedals.
Procedure:
- Press and hold the SETTINGS button (6) for 5 seconds.
The inversion of the pedals is instantly saved in the racing wheel’s internal memory, and one of the 4
RPM LEDs (7) flashes 3 times to indicate the selected position.
ACCELERATOR AND CLUTCH
PEDALS
FLASHING OF RPM LEDs (7)
DEFAULT MODE
- NORMAL position
- INVERTED position