ENGLISH-
BOOTLOADER METHOD: how to wake your racing wheel if it is no longer
recognized on PS3™, PS4™, PS5™ or PC
(i.e. in the event of firmware loss)
Required system: PC running Windows® 7, 8 or 10.
On PC, the USB sliding switch on the T150 racing wheel’s base
must always be set to the PS3 position!
1) If you haven’t already done so, install the DRIVERS FORCE FEEDBACK (Package) on
your PC. You can download it here:
https://support.thrustmaster.com/en/product/t150ffb-en/
During the installation:
- DO NOT CONNECT the racing wheel to the PC before being requested to do so.
- Connect the racing wheel directly to the PC’s USB port. We advise against using a
USB hub during this procedure.
- DO NOT CLICK on any windows that may appear during the update.
2) Restart the computer.
3) After restarting the computer:
- Remove the USB plug from the computer.
- Simultaneously press buttons L3 and R3 (located on the racing wheel’s base), then
connect (without releasing L3 and R3) the USB plug to the PC.
- The following message appears in the lower right-hand corner of your screen (do not do
anything or click on any window during the automatic installation procedure).
- After the installation, a second message appears:
Your racing wheel’s bulk drivers are now installed.
To Next Page
Loading...
Need help?
General
