Adjusting the SPACING of the three pedals
- Using the included 2.5 mm Allen key (3), unscrew the two screws holding the metal head (12) and its
support (11) in place.
- Select your preferred position (to the left, centered, or to the right), then replace and re-tighten the
screws so that the metal head (12) and its support (11) are held firmly in place.
Examples illustrating the brake pedal:
Left position Centered position
Right position
Number of possible spacing positions per pedal:
- Three for gas pedal
- Three for brake pedal
- Three for clutch pedal
Adjusting the INCLINATION of the pedals
- Using the included 2.5 mm Allen key (3), unscrew the two screws holding the metal head (12) and its
support (11) in place.
- Turn the plastic head support (11) 180°, then replace and re-tighten the screws so that the metal
head (12) and its support (11) are held firmly in place.
Examples illustrating the gas pedal:
Less inclined position (default) More inclined position
Number of possible inclination positions per pedal:
- Two for gas pedal
- Two for brake pedal
- Two for clutch pedal
To Next Page
Loading...
