Thrustmaster T300 User Manual

10/26
Attaching the racing wheel’s base to a cockpit
1. Place the racing wheel’s base on the cockpit shelf.
2. Drive two M6 screws (not included) through the cockpit shelf, then feed them into the two small
screw threads located on the underside of the racing wheel.
Important: The length of the two M6 screws must not exceed the thickness of the shelf + 12 mm;
longer screws could cause damage to internal components located in the racing wheel’s base.
3. If required, tighten the standard attachment system by inserting the fastening screw in the large
threaded hole.
PLAYSTATION®3 AND PLAYSTATION®4 MAPPING

Thrustmaster T300 Specifications

General

Force Feedback	Yes
Adjustable Pedals	Yes
Detachable Wheel	Yes
Motor Type	Brushless
Paddle Shifters	Yes
Compatibility	PC, Playstation 3, Playstation 4
Pedals	Yes
Wheel Diameter	28 cm
Connectivity	USB
Rotation Angle	270-1080°