SWITCHING FROM “RACING WHEEL MODE” TO “GAMEPAD MODE”
(and back)
• To switch the T80 Racing Wheel to “Gamepad Mode”:
(During this procedure, the PlayStation®4 must be turned on and the racing wheel's sliding switch (1) must be set
to “PS4”.)
- Press and hold the racing wheel's “PS” button (3), then connect the device's USB connector (1) to the
PlayStation® 4.
- After connecting the USB connector, release the “PS” button (3).
- Press the “PS” button (3) again, then connect to your profile; the racing wheel is now operational.
- The T80 Racing Wheel's LED (6) flashes continuously.
= The “Gamepad Mode” is active.
• To switch back to the T80 Racing Wheel's “Racing Wheel Mode”:
(During this procedure, the PlayStation®4 must be turned on and the racing wheel's sliding switch (1) must be set
to “PS4”.)
- Press and hold the racing wheel's “PS” button (3), then connect the device's USB connector (1) to the
PlayStation® 4.
- After connecting the USB connector, release the “PS” button (3).
- Press the “PS” button (3) again, then connect to your profile; the racing wheel is now operational.
- The T80 Racing Wheel's LED (6) no longer flashes continuously.
= The “Racing Wheel Mode” is active.
Important notes:
- The selected mode (“Racing Wheel Mode” or “Gamepad Mode”) is automatically saved to the device's
internal memory, even if the console is switched off or the racing wheel is disconnected from the
console. You therefore do not need to change it every time you launch your game.
- In “Gamepad Mode”, the racing wheel's sensitivity and responsiveness are significantly lower than in
“Racing Wheel Mode”. To ensure better playability in this mode, we therefore recommend that you
increase the T80 Racing Wheel's sensitivity (for more information on this subject, please refer to the
section below, “Adjusting the racing wheel's sensitivity in “Gamepad Mode”).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
