Thrustmaster TCA Quadrant Add-On Airbus Edition - Friction Adjustment Guide

8/14
ADJUSTING THE FRICTION
IMPORTANT NOTES:
- The friction on the TCA Quadrant Add-On Airbus Edition modules is set to 50% by
default.
- In order to allow for precise adjustment according to your preferences, y ou c an use a
screwdriver with the corresponding head shape (not included) — or the crossbar included
with the TCA Quadrant Airbus Edition — to turn the friction adjustment screws.
1. Push both TCA Quadrant Add-On Airbus Edition module levers forward to their maximum
values, and then access the friction adjustment screw at the back of each module.
2. To increase the friction, turn the friction adjustment screw clockwise.
3. To decrease the friction, turn the friction adjustment screw counterclockwise.
- To avoid damaging the friction system, be careful not to over-tighten the adjustment
screws: stop turning the screws when you feel resistance.
- Never completely unscrew the adjustment screws, to avoid the screws falling inside the
body of either TCA Quadrant Add-On Airbus Edition module.