@ffiF
PROP
t)t
19. Attach the tail
boom then reach two
pushrods
on the
servo.
Make
sure the
oushrod
should
be cross to each
other.
That
is to say the left elevator
servo controls the
right elevator. Secure the
servo
horn with
servo screw
when servo is in neutral
oosition.
20. Temporally install main wing on fuselage with four
3x20mm screws. Adjust the tail boom make sure V tail is
at
the same angle to the main wing next
glue
the tail
boom in
place.
22. Remove the main wing, install
the aileron servo horn
and
pushrod.
Thread
the clevis on the
pushrod.
23. Install the main wing again, adjust the
clevis and snap
it onto the control horn when
servo is in neutral oosition.
24. Secure the
motor
(
recommend Thunder Tiger
OBL29/09-07A)
with 3x5mm screw. Make
sure
the wires
do not contact to the motor can. Tape the wires if
necessary.Locate the Folding Prop
accessories as shown.
21. Adjust the clevis and snap on the elevator control horn.
To Next Page
Loading...
