THUNDER TIGER TOMAHAWK BX User Manual

CO Bunser
OPERATING RADIO THROTTLE/ BRAKE FUNCTION
ETE AP] > RR
. Check the radio throttle/brake functions. With the radio transmitter and receiver on, pull the trigger / push the stick forward. The
carburetor should be fully opened and the brake disengaged. To reverse this function, flip the throttle/brake servo reverse switch.
. Return the trigger to neutral. The carburetor should be closed to a point where the idle has been set (see step 11 for settings), and
the brake still disengaged. If not, use the throttle/brake trim lever to correct it.
. Push the trigger / pull the stick backward. The carburetor opening should still be the same at neutral, throttle spring compressed
slightly, and the brake engaged.
. EWA EHE ^ AISA E ERA B * MRD BP ` REESE RIFE o PEPR A EES
CARRETERES > ZERRE TARAS” EAEE) cCEDSOIAS SA ^ A APERA e
. TSOEIPSAR Mia] CD VERSES ^ (EORR TREES IE RERO ^ EDARRA : EARR BARA ^ aBadieRPgOWadin » CEPS ` E ERA
ERE 8B EAPERT)
. JEIPSARERII ZERO TIERS ^ (EXE SS TERES B ERG ^ REAA
ADJUSTING THROTTLE / BRAKE LINKAGE
BARRERAE PY 2A EAE
Bs JUR M CHITI ETE not hard to move
KERETES * AAR LEREBNE L ERR
. Idle: To set the throttle/brake linkage, first the radio should be on ( but do not start the engine)and the servo is at neutral position.
The factory setup of throttle linkage is about 28mm.(see picture) If it is not, please adjust the linkage to the proper length. The
carburetor opening should be in the idle position. (almost closed, but remain about 0.5-1mm opening inside the carburetor)
. Full throttle: Now pull the full throttle. The brakes should disengage immediately. The carburetor should be fully open. If the
carburetor is not fully open, adjust the throttle linkage into 28mm (see above) to get the carburetor fully open. You may also adjust
your throttle trim according to your radio's instructions.
. Brake: Push the trigger / pull the tick backward. The carburetor opening should be in the idle position. (almost closed, but remain
about 0.5- 1mm opening inside the carburetor), but the spur gear will be hard to move. If it is not engaged, adjust the collars (next
to the spring) or setup in your radio to get the brake to engage properly. Be ware that the servo spring should not be completely
compressed;
. AR : EHRE BARE TET RA NE RECHE” EMEJRR UT S E SE RTMSCERPHHREHER REST e RA
PIERE 28mm GEN) : QÜUEGETEEISARIETÉ : SEV GAP ESSERE » [Gs » (ESSE EXE SP Se RES ERA RE ZARE
A33 PS E8530. 5-1 mmÉ 9 BRL)
; ep: EPAPER s [ESSERE IERXIE : (EoEIESERZEBDBHEX » UROSA ANETE * SBEX TOBIPHXEIREE TREES ^ SX
ARANNA Armak GRET ^ ARER EnA) *
. AE: AER (CHERA RA — ER (8 IE ERR AC BIP IE EB $30.57 1mmBSBSLT) » EE a A AURRERA
RS AARRE LAAR Ea) RR RE ARRERA E (ARRET ^ 88
DASEETHESSESEBIRASIKUE) AARRE EAE |
10

THUNDER TIGER TOMAHAWK BX Specifications

General

Brand	THUNDER TIGER
Model	TOMAHAWK BX
Category	Motorized Toy Car
Language	English