Thunder Multi-Function Jump Starter User Manual

5
JUMP START 12 VOLT VEHICLE INSTRUCTION
CHARGING ELECTRONIC DEVICES
Charging Electronic Devices
Charging Mobile Phone or Tablet
1. Plug the Switch Cable B to USB 5 Volt 2 Amp output port.
2. Select appropriate connector & connect it to your mobile phone or tablet.
3. Turn the Thunder Jump Starter ON to charge device.
Power Supply to 12 Volt Products
1. Plug the optional Switch Cable into the 12 Volt 10 Amp output port.
2. Connect your 12 Volt load to the power socket.
3. Turn the Thunder Jump Starter ON to charge device.
Charging / Power Supply to 19 Volt Laptop
1. Plug the Switch Cable A to 19 Volt 3.5 Amp output port.
2. Select appropriate connector for your Notebook & connect it to the Switch Cable A
& your Notebook.
3. Turn the Thunder Jump Starter ON to charge device.
LED Torch
Press the ON / OFF Switch for 3 seconds to start the LED Torch.
There are 3 modes available for Torch use - Normal, Strobe & SOS.
Mode is changed by depressing the Switch half way.

Thunder Multi-Function Jump Starter Specifications

General

Brand	Thunder
Model	Multi-Function Jump Starter
Category	Remote Starter
Language	English