its weight by pressing the OK key, and the weight will disappear from the display again
for 0.5 seconds. The OK key can only be pressed once while the animal is on the
platform, and will not be available after the weight returns to zero.
A weight is added to the statistics only once automatically while a weight is applied, and
the sequence will reset only after the weight returns to zero.
Statistics
Statistics may be accumulated on animals or objects weighed. The recorded weight is
entered into an overall statistics collation, as well as draft statistics if draft mode is on.
There are up to 5 sets of draft statistics, depending on how many ways the draft mode
has been programmed for. This means that there are up to 30 separate statistical
values recorded.
All statistics are remembered when the T30 is turned off, provided it is turned off using
the on-off button. The statistics will not be saved if the battery is simply unplugged
while the internal battery is flat. This applies also if the battery lead is accidentally
disconnected. This feature is to allow a break in a weighing session, and then continue
with the same session at a later time. The statistics must be cleared if a new weighing
session is to be recorded. Otherwise the weights will be added to the old statistics.
There are 5 distinct values recorded for each range of statistics. They are;
number weighed
minimum weight
maximum weight
average weight
total weight
To view the statistics, press stats. The overall number weighed will be displayed. Use the arrow
keys to scroll up and down the overall statistics values. The statistic displayed will be indicated
on the screen. The statistics mode can be exited by pressing the weigh key.
If the draft mode is on, the draft statistics may be view by subsequent pressings of the stats
button. The screen will indicate which draft statistic is being displayed by showing LOW, MID
or HIGH, or a combination of two. Use the arrow keys again to scroll through the values for
each draft range.
To exit the statistics display function, press weigh. Normal weighing will resume.
To reset the statistics, press stats, and then press tare. ‘Clr?’ will be displayed. Press the up
arrow or OK to confirm, or the down arrow to keep them. All values will be reset to zero once
the up arrow has been pressed.
There are 2 ways of adding to the statistics. They are:
1. Manual entry. OK must be pressed each time a weight is to be added to the
statistics. The weight may be added in either livestock mode, and only the weight
displayed at the time will be added. This method will not work if auto tally is on. For
To Next Page
Loading...