livestock locking mode, the statistic will only be added when OK is pressed after the
large lock icon appears. For livestock mode, the statistic will only be added when
OK is pressed after the cow icon disappears for 0.3 seconds. The weight will
disappear from the display for 0.5 seconds to confirm that the weight has been
entered into the statistics. Pressing the back key will cause the weight to be removed
from the statistics if the weight is still applied, and pressing the OK key again after
the back key has been pressed will add the weight to the statistics again, but only if
the weight continues to be applied. These buttons will not work after the weight
returns to zero.
2. By autotally. Autotally will only work in a livestock mode. Please refer to the
Autotally section.
Note: The weight automatically recorded may not be the true weight if the beast pauses while
moving on to the scale using autotally. Please refer to the Autotally section.
Increments
The T30 displays in varying weight increments, depending on a number of factors.
These factors include the capacity of the system, the weighing mode, and the amount of
weight applied. The guide below shows the increments used.
If system capacity is 200kg (440lb) or less;
General - 0.1kg (0.2lb)
Livestock - 0-50kg (0-110lb), 0.2kg (0.4lb)
50-200kg (110-440lb), 0.5kg (1lb)
For 201kg (441lb) to 2000kg (4400lb) load cell systems;
General - 0-50kg (0-110lb), 0.1kg (0.2lb)
50-500kg (110-1100lb), 0.2kg (0.4lb)
500-1000kg (1100-2200lb), 0.5kg (1lb)
>1000kg (2200lb), 1kg (2lb)
Livestock - 0-100kg (0-220lb), 0.5kg
100-500kg (220-1100lb), 1kg (2lb)
>500kg (1100lb), 2kg (5lb)
For systems over 2000kg (4400lb);
General - 0-50kg (0-110lb), 0.2kg (0.5lb)
50-500kg (110-1100lb), 0.5kg (1lb)
>500kg (1100lb), 2kg (5lb)
Livestock - 0-100kg (0-220lb), 1kg (2lb)
100-1000kg (220-2200lb), 2kg (5lb)
>1000kg (2200lb), 5kg (10lb)
Error Messages
The T30 has a very comprehensive self monitoring system that detects any problems
that may occur. Should such a problem be detected, an error message will be
displayed on the screen, for example ‘Er36’. Most error messages displayed concern
problems with the signal coming from the weigh bars or load cells. The signals from the
To Next Page
Loading...