Page 2 For technical questions, please call 1-888-866-5797. Item 57325
SAFETY OPERATION MAINTENANCESETUP
Table of Contents
Safety ......................................................... 2
Specifications ............................................. 5
Setup .......................................................... 5
Operation .................................................... 6
Maintenance ............................................... 7
Parts List and Diagram ............................... 8
Warranty ..................................................... 8
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
IMPORTANT SAFETY INSTRUCTIONS
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
READ ALL INSTRUCTIONS
Installation Precautions
1. Exercise special caution if working on roof
or another high location. Keep proper footing
and balance at all times. Follow ladder supplier’s
precautions whenever working near or on a ladder.
2. Install all sensitive electrical components
(including wiring connections, regulator,
and battery) inside a weatherproof
enclosure to prevent electric shock.
3. Do not wire multiple panels in series. If you
need to connect two or more solar panels together,
this work must be done by a qualified electrician
unless they are connected through a regulator.
4. This solar panel is not designed for tie-in to a grid.
Only a licensed electrician and a licensed building
contractor can safely design and implement a
grid tie-in system. Any grid tie-in system must
meet all applicable building and electrical codes,
and must meet standards established by the area
power company. Improper grid tie-in can result
in electrocution, fire, and other serious personal
injury and property damage. An incorrectly installed
grid tie-in system can cause feedback voltage,
resulting in electrocution of electrical utility workers.
5. Do not stand on or otherwise
apply pressure to panel.
To Next Page
Loading...