Page 3For technical questions, please call 1-888-866-5797.Item 57325
SAFETYOPERATIONMAINTENANCE SETUP
6. Handle solar panel with care,
edges may be sharp.
7. Do not focus light on panel.
8. Install components with enough
space to allow proper cooling.
9. This product may occasionally produce
more current and/or voltage than its rated
output. Increase output ratings by 25% when
determining component required voltage
and amperage ratings. Refer to Section
690-8 of the National Electrical Code for an
additional multiplying factor of 125 percent
(80 percent derating) which may apply.
10. Panel must be connected using UL listed outdoor
rated wire of the correct thickness (gauge) for the
amperage rating and length (see warning number
9 also). Follow the guidelines in the chart below:
Current
in Amps
Maximum Length
5' 10' 15' 20' 25'
0-5 18
6-7 18 16
8 18 16
10
18
16
11-12 16 14
15
14 12
18
18 1620 14 12
10
22-24 12
30
16
14 10
40
12 10 8
50 14
100 12 10 6 4
150 10 8
4 2
200 8 6
Minimum Wire Gauge
11. Do not attach panel to power grid without proper
regulator, inverter, and/or charge controller.
12. Install and use according to applicable
National Electrical Code (NEC) standards.
13. This panel is not rated for use as fire-resistant
roofing. If installing on a roof, install only over a fire
resistant roof covering rated for the application.
14. Verify that installation surface has no hidden
utility lines before drilling or driving screws.
15. Install only according to these instructions.
Improper installation can create hazards.
16. Do not leave this solar panel attached to an
automobile or trailer while it is in motion.
17. Handle panel with care. Glass may break or a
sharp edge may be exposed during movement.
18. Keep installation area clean and well lit.
19. Install out of reach of children.
20. Keep bystanders out of the area during installation.
21. Do not install when tired or when under
the influence of drugs or medication.
22. This should be used to charge a 12V battery
using a charge controller (sold separately).
23. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
Battery Precautions
1. Wear splash-resistant ANSI-approved
safety goggles and electrically insulated
gloves while working near batteries.
2. Use an appropriate charge controller
whenever connected to battery.
3. Charge, store, and maintain batteries
according to supplier’s instructions.
To Next Page
Loading...