ThyssenKrupp Flow2 User Manual

2007.03.07Flow2 stairliftTab 06: Systematic fault finding
www.ThyssenKruppAccessibility.nl18
Error messages
Possible
solution
- Check the flat cable between the power module and the mainboard.
- Switch the lift off and on.
- Set the parameters and table back to the factory settings.
- Replace the main board if none of the above solutions has helped or if the
fault keeps coming back. This is an extreme measure.
Reset Switch the lift off and on.
Modes 0, 1, 2, 3, 6
The error is disabled in mode 4 and 5.
Error code E02
Type of error System error
Error message Service unit circuit error
Description Indicates that the service board is defective or not switched on.
Priority Highest
Possible
solution
- Switch the lift off and on.
- Check whether the connectors are firmly pushed home.
- Check whether the cabling is damaged. Replace this if necessary.
- Check whether replacing the service board solves the problem.
- Replace the main board if none of the above solutions has helped or if the
fault keeps coming back. This is an extreme measure.
Reset Switch the lift off and on.
Modes 0, 2
Error code E03
Type of error System error / control error
Error message Read parameter error
Description This fault indicates that one of the stored settings is corrupt. This message
mainly appears when, during switching on, the parameter settings are read out.
Because the lift cannot operate without correct rail data, a standard table is
created where the speed is set to 30% and the swivel angle to 0º.
Priority Highest

ThyssenKrupp Flow2 Specifications

General

Brand	ThyssenKrupp
Model	Flow2
Category	Stairlifts
Language	English