4.5.4 Accepting incoming calls
The landline is connected to the Communication Module. An incoming call can therefore
also be accepted while using the stairlift.
1.
1 s
When there is an incoming call, the Communication Module produces a ring tone.
Accepting the call is done as follows:
1. Briefly press the yellow alarm button once. The connection is now established.
Speak in the direction of the alarm button to communicate.
The call can be ended by pressing the yellow alarm button for 1 second.
4.5.5 Error codes
LED colour Sound Cause
Flashing red None Not connected to a base
station or no base station
selected
Flashing red Two short beep sounds, not
repeating.
CM power supply is lost or
backup battery is charging
Flashing green Two beep sounds,
repeating every 2 minutes
The CM tries to reconnect to
the registered base station
When calling, flashing red Two beep sounds, 1 second
pause, two beep sounds,
not repeating
No telephone numbers
programmed
Green (after trying to call) None No telephone line present
For other questions, please contact your supplier.
32 Use
To Next Page
Loading...
Need help?
General
