Thytronic XMR-V 4V

To Next Page

To Previous Page

FUNCTION CHARACTERISTICS

Use of output relay:

• If the Z<BLK2OUT and/or Z<<BLK2OUT enable parameters are set to ON and a output re-

lay is designed for selective block (Block2), the protection issues a block output by phase ele-

ments (BLK2OUT-Iph) or by any protection element (BLK2OUT-Iph/IE), whenever the given ele-

ment (Start I(H)>, Start I(H)>> e/o Start I(H)>>>) becomes active. The enable

Z<BLK2OUT

and/or Z<<BLK2OUT parameters (ON or OFF) are available inside the Set \ Proﬁle A (or B)

\ Underimpedance-21 \ Z< Element (Z<< Element) \ Setpoints menus, while the BLK2OUT-I-

ph-K,BLK2OUT-Iph/IE-Kand/or BLK2OUT-IE-Koutput relays and LEDs (BLK2OUT-Iph-L,

BLK2OUT-Iph/IE-Le/o BLK2OUT-IE-L) must be select inside the Set \ Proﬁle A (or B) \ Selecti-

ve block-BLOCK2 \ Selective block OUT menu.

XMR-D EQUIPMENT MANUAL

Ed. 2.9 - 02/2021

Thytronic XMR-V 4V - Page 84