What to do if the TIA Microwave Oven display is active, +/- respond, counts down when “Start” is pressed, turntable turns, but microwave does not heat?
If the turntable turns but the microwave doesn't heat, check for relay failure. If that's not the issue, check for noise filter failure. If the problem persists, check for power supply or magnetron failure.
Why is the display not illuminated on my TIA Microwave Oven?
If the display numbers are not illuminated, it could be due to several reasons: * No or low input voltage: Measure the input voltage; it should be 28 Volts DC. Check the load shed circuit on the aircraft. * Check the load shed circuit on the aircraft and load shed fuse in the microwave. * Check the load shed fuse in the microwave (P/N 400-1860-01 only) and noise filter. * Noise filter failure: Check the controller card for failure. * Controller card failure: Check the liner overheat thermostat. * Check the liner overheat thermostat.
What to do if the TIA Microwave Oven display is active, controls are unresponsive?
If the display is active but the controls are unresponsive, check the switch panel overlay for failure. If the issue continues, check the controller card for failure.
What to do if the TIA Microwave Oven display is active, +/- respond, counts down when “Start” is pressed, turntable does not turn and microwave heats?
If the turntable does not turn but the microwave heats, check for inverter board failure and then check for turntable motor failure.
What to do if liner or magnetron thermostat opens frequently in TIA Microwave Oven?
If the liner or magnetron thermostat opens frequently, check that the microwave installation allows for adequate fan ventilation. Also, check for power output.
How to fix TIA Microwave Oven when display is active, +/- respond, but will not count down when “Start” is pressed and inside lamps stay on?
If the display is active, the +/- buttons respond, but the microwave will not count down when “Start” is pressed and the inside lamps stay on, check all door interlock switches. One or more may be stuck open or need adjustment.
What to do if TIA Microwave Oven display is active, +/- respond, counts down when “Start” is pressed, turntable does not turn and microwave does not heat?
If the display is active, the +/- buttons respond, the microwave counts down when “Start” is pressed, but the turntable does not turn and the microwave does not heat, check the magnetron thermostat to see if it is open. Verify the cabin altitude is less than 9,000 feet. Check the altitude switch and check for controller card failure.
Why don't the lamps light in my TIA Microwave Oven when display is active, +/- respond, counts down when “Start” is pressed, turntable turns and microwave heats?
If the display is active, the +/- buttons respond, the microwave counts down when “Start” is pressed, the turntable turns and the microwave heats, but the lamps do not light, the lamps have burned out and need to be replaced. TIA recommends that the lights be replaced in sets.
Overview of the oven's features, reliability, and load shed circuit functionality.
Instructions for using the microwave, including setting time and cooking.
Outlines equipment needed and steps for functional testing of the oven.
Lists common faults, probable causes, and fault isolation tables.
Details visual inspection points and functional checks for proper operation.
Covers general repair, lamp, wiring, and turntable component replacement.
General| Brand | TIA |
|---|---|
| Model | WAVEJET 400-1860-01 |
| Category | Microwave Oven |
| Language | English |
To Next Page