Tie Down Engineering 80 User Manual

061812,C366
Instructions for
Bleeding Tie Downs
Model 660, 700 &
800 Actuators
Normal Operation
Emergency Stop Position
TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
To pump master cylinder, insert a flat tip screwdriver into the round hole near the front of the actuator cover
(See 1A). The screwdriver should be at the lowest angle possible to the actuator so that it slides in front of the
e-stop bracket (See 1B). Screwdriver tip MUST BE IN FRONT of the e-stop bracket and NOT in the slot on the
e-stop bracket (See 2A). Push the screwdriver forward and back to pump the master cylinder. (See 2B).
1B
1A
WARNING: If button stop cable is showing
DO NOT TOW TRAILER
Release emergency stop cable by prying
spring out with a flat blade screw driver.
Button Stop
Bleeding
Access
Incorrect
DO NOT USE SLOT
Correct
Front of Bracket
Place Screwdriver
Tip Here
2B
2A

Tie Down Engineering 80 Specifications

General

Brand	Tie Down Engineering
Model	80
Category	Controller
Language	English