Need help?Do you have a question about the Tiffen Steadicam M-2 and is the answer not in the manual?
Details electrical connectors and ports on the stage front and rear.
Explains how to mount and remove a camera using the dovetail lock system.
Describes how to adjust stage balance using fore-aft and side-to-side knobs.
Explains how to adjust camera tilt relative to the post using the tilt stage.
Explains switching between Normal and Friction modes and setting tilt trim.
Details how to customize roll, tilt, and damping using the dial box.
Provides recommended Volt system settings for various shooting scenarios.
How to adjust the dovetail clamp for optimal clamping force and ease of use.
Instructions for adjusting tension on balance drive knobs.
Step-by-step guide for installing Volt electronics into the top stage.
Instructions for installing or repositioning Volt control boxes on the stage nose.
Details how to adjust the low-profile post clamps for a secure lock.
Explains how to disconnect and reconnect stage, post, and base components.
Guide for detaching and reattaching the base of the Steadicam rig.
Details the components of the gimbal when equipped with Volt electronics.
Compares Volt integration differences between M-2 and M-1 gimbals.
Explains how to adjust the low-profile gimbal clamp for secure post connection.
Step-by-step guide for removing and cleaning the gimbal's pan bearing.
Instructions for reassembling and replacing the gimbal's pan bearing.
Guide on how to position the monitor mount for optimal viewing and balance.
Details the operation of the clamp for moving the monitor mount.
Explains how to adjust the monitor mount's yoke for width and height.
Instructions for adjusting the monitor rod clamps and pivot hinge brakes.
Details the front and rear electronic ports and switches on the base.
Explains how to position batteries on the mount for balance and clearance.
Guide for installing the optional third battery mount.
Explains battery combinations and switch functions for power management.
Details pin configurations for various connectors on the M-2 system.
Critical warnings about accessory mounting and voltage output characteristics.
General| Adjustable Height | Yes |
|---|---|
| Material | Aluminum and Steel |
| Gimbal | 3-axis |
| Post Material | Aluminum |
| Type | Camera Stabilizer |
| Vest Type | Not Included |
| Included Accessories | Carrying Case, Docking Bracket |
To Next Page
