Page of 104
• DISCONNECT TOOLS FROM POWER SUPPLY before servicing and when changing
accessories, such as blades, bits, cutters, and the like.
• REDUCE THE RISK OF UNINTENTIONAL STARTING. Ensure that the switch is off before
plugging into power source.
• USE RECOMMENDED ACCESSORIES. Consult the owner’s manual for recommended
accessories. Use of improper accessories may cause risk of injury to persons.
• NEVER STAND ON ELECTRIC SHARPENER. Serious injury may result if the tool is tipped or if
the cutting tool is unintentionally contacted.
• CHECK DAMAGED PARTS before further use of the electric sharpener. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that
may affect its operation. A guard or other part that is damaged should be properly repaired or
replaced. DO NOT USE A MACHINE WITH A DEFECTIVE ON/OFF SWITCH.
• DIRECTION OF FEED. Only feed work into the blade against the direction of rotation of the blade.
• NEVER LEAVE TOOL RUNNING OR UNATTENDED. Turn the power off and do not leave the
electric sharpener until it comes to a complete stop.
CHAINSAW SHARPENER WARNINGS
Before operation of the electric sharpener, read the instruction manual carefully. If you have any
questions regarding the condition and operation of the tool, consult the manufacturer.
Protect the electric sharpener from moisture, rain, and dust. This tool is only for indoor use.
For the highest degree of safety, carefully read the following instructions:
• Use the electric sharpener only for its intended use.
• Never start the sharpener without the wheel guard in place.
• Never use the sharpener as a cutter for grinding objects other than chainsaws.
• The sharpener can be used continuously for no more than 15 minutes; then, turn it off for an
adequate period of time.
• ALWAYS wear hearing and eye protection at all times. Wear a dust protection mask when needed.
The noise level in the work area can be above 85dB, and eyes can be protected from flying chips
and debris with safety goggles.
• Wear work gloves to protect fingers and hands from cutting injuries.
• Unplug the electric sharpener before doing any maintenance work on the machine.
• Ensure that the chain is sharpened and secured in place so that it doesn’t slip out.
• Keep the electric sharpener clean and check for any damage.
• ONLY use soap and water to clean plastic parts.
• Do not use the electric sharpener near any flammable liquids or vapors.
• Protect the power cord from damage by oil or acid.
• IMPORTANT: Observe all national safety regulations regarding installation, operation, and
maintenance.
• After completing a job, unplug the electric sharpener from its power source.
• Store the machine in a safe, dry, locked location out of the reach of children.
• Always use both hands to hold the machine when working. Maintain safe footing and good
posture.
• Inspect sharpening wheels before each use.
To Next Page
Loading...
