Page of 105
• ALWAYS replace a cracked wheel immediately.
• Always use guards and eye shields at all times.
• Do not over tighten wheel nut.
• Protect yourself from electric shock. Avoid any bodily contact with grounded objects such as pipes,
radiators, stoves, and refrigerators.
• Do not overload the machine – work in a safe manner within the scope of the machine’s capacity.
• Do not use the power cord for carrying or hanging the machine. Do not use the cord to pull out the
plug from the outlet.
• Check the machine cord regularly; when it is damaged, have it replaced by a skilled electrician.
Check the extension cords as well and replace them if damaged.
• Be attentive. Start a job only when you feel good. Never use the electric sharpener when distracted
by others.
CAUTION: Abide by the essential safety measures protecting you from electric shock,
accident, and fire. Read all instructions before using the electric sharpener for chainsaws and
follow them. Keep this manual in a safe place for future reference.
NOTE: This machine is in compliance with any respective safety provisions. Any repairs should be
done by professionally qualified technicians and only genuine spare parts should be used. If these
provisions are not observed, the user is in risk of injury.
READ ALL WARNINGS BEFORE OPERATION
ASSEMBLY:
ATTENTION: The sharpener should only be used in a place protected from dust and
dampness, well-lighted, away from children, gases, or other flammable or explosive liquids. It
should be placed near a suitable earthed outlet, and do not use dangerous extension cables.
1. Fasten the sharpener onto the bench with two M8 bolts (not provided) after having carefully
positioned it on the bench.
2. When the sharpener is fastened onto the bench, use a suitable square support, making sure that
the sharpener is not fastened at the level of the operator’s eyes. It is recommended that you install
the sharpener at a maximum height of 47”-51” from ground level.
3. Slide the head of the M6x25 screw onto the sharpener as shown below, then attach handle to
M6x25 screw. Make certain the head of the M6x25 screw is at the end of its slot, if not, the wheel
guard cannot be installed.
To Next Page
Loading...
