5. Set up
(1)
HARNESS
(1)
W
ARNING
AL
WAYS WEAR THE PROVIDED HARNESS WHEN
USING THE MACHINE!
Al
ways make sure the machine is hooked securely
to the harness.
If you don't, you will be unable to control the machine
safely. This can result in injury to yourself or others.
Never use a harness with a defective quick release
or any other damage.
HOW TO WEAR
1. Wear the provided harness without twisted bands, with
the hanger on your right side.
(1) Hanger
BALANCE THE UNIT
1. Hook your machine to the hanger.
2. Adjust the bands of the harness to have the blade
parallel to the ground when standing in your normal
working position to provide you most effectiveness
and comfort on operating the machine.
3. In order to prevent the hanger position to change
during operation, turn up the extra part of the band
from the buckle.
QUICK RELEASE
The har
ness is equipped with a "QUICK RELEASE"devise.
T
o release the machine from the harness in emergency
situations, please follow the procedure as explained
below.
W
ARNING
Make sure to check proper working of the QUICK RE-
LEASE device BEFORE operating the machine.
Make sure to hold the unit securely when using the
QUICK RELEASE.
While holding the unit by your right hand securely, press
both sides of the
buckle. sides of the buckle.
(1) Buckle
4
. When correctly adjusted, check the correct working
of the harnesses' QUICK RELEASE.
GB 7
To Next Page
Loading...