RTM Carbon Matrix + TIME
VIBRASER technology
Compression
cap
Stem spacer kit
TransLink joint
TransLink cutting tool
Front and rear brake nuts
Cable sleeve under bottom bracket
Quick Set adjustment pins
TIME NX component composition:
Technical specifications:
- Wheel diameter 700C
- Tire cross section 700 x 23
- Front hub width 100 mm
- Rear hub width 130 mm
- Bottom bracket width 68 mm
- Bottom bracket Standard BB30
- Crankset w/double chainring 43,5 mm
- Crankset w/triple chainring 46,5 mm
- Seatpost Specific
- Front derailleur type A braser
- Rear derailleur support M10 x 100
- Brake caliper Standard shoes
(Route 39/50)
- Headset Integrated
Nota: The TIME NX conforms to the standards EN 14781
It is protected under the following patents:
- Quick Set Headset: EP 1 569 843 and US 7 237 787
- Multi-diameter pivot: FR 2 807 382 and US6 805 372
- Composite pivot: EP 1 015 301
SAFETY INFORMATION
The TIME modules or frames are high end products and they contain every safety security when used as
intended. Please read carefully the following instructions, ensuring a safe use.
Tightening torques:
Carefully follow all tightening torques in order to maintain proper function and security.
Use a high quality torque wrench.
- Saddle clamp = 8 Nm (rear bolt)
- Saddle = 5 Nm
- Rear stem bracket = 5 Nm
- Front stem bracket = 6 Nm
- Brake nuts = 6 Nm
- Front derailleur support = 7 Nm
Replacement parts:
- Only use original parts when replacing worn parts (bearings, derailleur supports, etc.)
To Next Page
Loading...