8. Commissioning:
• Switch on the 230V AC 50Hz mains supply to the Control Unit and
check that the ‘on’ indicator (green) is illuminated. The Alarm indicator
(blue) should be off.
• Test the alarm system by pulling the Pull Cord Unit, the alarm will
trigger the sounders on the Over-Door Light as well as the Single Zone
Control Unit. The Pull Cord Unit, Reset Unit and the Over-Door Unit will
all emit a static blue light during the period that the alarm is triggered.
• Press the Reset button on the Control Unit to end the alarm.
Test the alarm once again by pulling the Pull Cord Unit, this time
use the Reset Unit to end the alarm.
9. Operation:
• When the pull cord, mounted adjacent to the W.C. is pulled,
the blue LED on the Pull Cord Unit will be activated until
the system is reset, assuring the disabled person in distress
that the system has been activated.
• At the reset unit inside the cubicle, the light and sounder
will simultaneously trigger and remain on continuously;
which will further reassure the person in distress.
• The sounder and the light on the Over-Door Unit outside the cubicle
will remain on until the alarm system has been reset.
• At the Control Unit the blue alarm light and the sounder
are activated continuously.
• Either the Over-door Unit or the Control Unit will attract the attention
of an appropriate person either directly or indirectly and that person will
note the system is in alarm, press the reset button at the Control Unit
clearing the alarm and will then investigate the cubicle in question.
• At any time if the difficulty is resolved the person in distress can clear
the alarm by pressing the reset button in the cubicle.
To Next Page
Loading...
Need help?
General
