Loosen Tighten
The Installation and Usage of Dripper Bracket
Fastening the
large knob
2. Loosen the large side knob to move
the dripper holder freely to adaprt to
dierent height combinations of the
dripper and the coee server.
After the height is adjusted to the
proper height, the knob needs to be
securely tightened.
1. The dripper holder can be easily
installed and removed. Please remove
the silicone pad before installation.
The connecting piece/screw on the
back of the base is fixed and should
not be pulled out.
Insert the rod into the hole as shown,
fix and tighten the screw below the
connecting piece to fix the bracket
(see the figure below).
3. When the dripper holder is locked, it
can still rotate freely from the middle
position to the left and right. Do not
exceed the angle range.
knob
Lock
To Next Page
Loading...