Welcome to the Argus Quick Start user manual.
This guide is intended for those users that have had prior experience with TimeTronics photo finish products and wish
to have a quick overview of how the new Argus Photo Finish cameras operate. This guide assumes that the user has the
software installed correctly and all hardware connected. For those users that require more detail into the overall
functionalities of the Argus Photo Finish cameras (with set up information and troubleshooting), please see our full ‘Argus
Photo Finish Manual’.
Please note that all pictures are examples, the delivered version can be different than shown in this manual please
inform yourself before purchase.
If you, after reading this document, have any further question regarding the operation or service of this or any other
TimeTronics equipment, please contact your local distributor or TimeTronics directly, by email: info@timetronics.be, or
call us at +32 (0) 14 23 19 11.
Please also contact us if you have any remarks or advice regarding this user manual: info@timetronics.be
Good luck and thank you for your confidence in the TimeTronics products and services.
The editors
© Copyright 2020 TimeTronics. All rights reserved.
TimeTronics bv
Lammerdries-Oost 23b
B-2250 Olen
Belgium
Tel.: +32 (0) 14 23 19 11
Disclaimer
Under no circumstances shall TimeTronics be liable for any loss, damage or expense suffered or incurred with respect
to any defective product. In no event shall TimeTronics be liable for any incidental or consequential damages that you
may suffer directly or indirectly from use of any product.
To Next Page
Loading...
Need help?
General
