First you will need to locate the licence key for your camera. This can be found on the USB drive
inside the carry case of your Argus photo finish camera delivery. The file you require will be
Argus xx-xx-xx.lic (where xx-xx-xx is replaced by the serial number of your camera).
To load the licence key into the Argus software, you need to go to the
‘i’ icon on the top left of the software window and press ‘about’
In the ‘About’ window, press the ‘+add’ icon and locate your .lic file to load into the software.
When this has loaded correctly, you will see the serial number of your photo finish camera in the
‘About’ window and you will see (when you click on the camera number) the camera functionality
information to the right.
You can now close this window and we can begin to use your new Argus photo finish camera!
To Next Page
Loading...
Need help?
General
