Timex Sinclair 2020 Computer Program Recorder - Power Sources

18 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

POWER

SOURCES

•

USING

BATTERIES:

1.

Open

the

lid

of

the

battery

compartment.

2.

Install

four

1.5V

AA

Alkairie penlight

batteries

observing

the

polarity

marked

on

the

inside

of

the

battery

compartment.

3.

Id

you

do

not

intend

to

operate

the

set

on

batteries

for

an

exi

ended

period

of

lime,

remove

the

batteries

to

avoid

possible

corrosive

leakage.

•

USING

TS2D2D

AC

ADAPTOR

(OPTIONAL)

Connect

the

cable

from

the

AC

Adaptor

to

the

external

DC

GV

jack

on

the

rear

of

the

computer

program

recorder.

Connect

the

AC

adaptor

to

the

wall

AC

power

source.

NOTE:

Use

of

AC

Adaptors

other

than

the

TS

2020

AC

Adaptor

is

not

recommended

and

may

damage

the

recorder.

If

other

adaptors

are

used,

proper

polarity

must

be

observed.

—

#

i

DC

6V.

3

Table of Contents