that will be replaced by an alarm time. At the top, it will say T1 or T2, followed either by some
dashes, or a month and date. In the middle, it will show a time, and at the bottom it will give the
alarm number. You can set up to 5 alarms on this watch. To choose between the 5 alarms, press
the RECALL button.
2. To set the alarm you have selected, press & release the SET button. T1 (or T2) begins to flash.
This tells the watch whether this alarm should go off according to the time you have set in your
1st time zone, or according to the time in the 2nd time zone. Press the RECALL button to choose
between T1 or T2.
3. Press the START/STOP (lower right button on the face) button and the AM or PM will begin
flashing. Choose whether you want the alarm to go off in AM or PM by pressing the RECALL
button.
4. Press the START/STOP button and the hours will begin flashing. Choose the hour by pressing the
RECALL button. If you pass the hour you want, you can back up by pressing the STOP/RESET
button (the lower left button on the face).
5. Press the START/STOP button and the minutes will begin flashing. Choose the hour by pressing
the RECALL button. If you pass the minute you want, you can back up by pressing the
STOP/RESET button.
6. Press the START/STOP and the months position will begin flashing. If you want the alarm to go
off as a daily alarm, then leave this as dashes. If you want the alarm to go off as an anniversary
(yearly) alarm, then press the RECALL button to set the month. If you pass the month you want,
you can back up by pressing the STOP/RESET button.
7. Press the START/STOP and the days position will begin flashing. If you want the alarm to go off
as a daily alarm, then leave this as dashes. If you want the alarm to go off as an anniversary
(yearly) alarm, or as a once-a-month alarm, then press the RECALL button to set the date. If you
pass the day you want, you can back up by pressing the STOP/RESET button.
8. When everything is set the way you want it, you may get out of setting mode and lock your
settings in by pressing the SET button.
Arming and Disarming the Alarm
When you are in ALARM mode (but not in setting mode) you may turn your alarm on or off by pressing
& releasing the START/STOP button. A little symbol that looks like a clock will appear above the M in
AM or PM when the alarm is armed. If it is disarmed, that symbol will not be there. If that symbol is
showing when you are in regular time mode, then at least one of your 5 alarms is armed. You can go to
alarm mode and use the RECALL button to scroll through all 5 alarms to see which ones are armed.
Arming and Disarming the Hourly Chime
Added by Frank Haney:
The hourly chime is enabled/disabled by pressing the STOP/RESET button when you are in the ALARM
mode. When it is enabled a symbol that looks like a musical note is displayed next to the alarm symbol.
The watch will beep as you disable it.
5. MEMO
The last mode is the MEMO mode. You have up to 10 memos with 3 "pages" each. These pages each
hold 8 characters. The characters can be letters, numbers, or a few punctuation symbols. Choose a memo
by pressing & releasing the RECALL button. Scroll through the pages of the memo by pressing &
releasing the START/SPLIT button. Clear a memo by pressing & holding the STOP/RESET button.
To enter a memo or change an existing one, press & release the SET button while in MEMO mode.
Repeatedly press & release the RECALL (scroll up) or the STOP/RESET (scroll down) button to select
the character to put in the space that is flashing. Press the START/SPLIT to advance to the next space.
To Next Page
Loading...
Need help?
General
