Timex 80 - Page 4

Disassembly of movement for Cleaning (model 80)
DIAL PLATE
MOVEMENT PLATE
a) Remove the sweep second hand,
do not remove the minute or
hour hand.
b)
The dial is clamped to the
movement
by means of tabs
which are inserted through
dial
holes located in the dial spacer
and
dial plate. The tabs are
bent under the
dial plate.
c) Once the dial is off the move-
ment, there
is no need for furth-
er disassembly
in the dial area
unless severe contamination is
present on the friction and can-
non pinions. Should
further
disassembly be necessary, re-
moval
of the minute hand will
free the friction and cannon
pinion assembly.
The friction
pinion
is held in the cannon
pinion
by a snap fit.
80.3