Timex 80 - Page 7

Lubrication of (Model 80)
INTERWIND PINION AND
STEM WIND PINION
~~~~ WIND AND SET
PINION
SECOND PINION
PIVOT
PALLET
STAFF
PIVOT
THIRD PINION
PIVOT
HOLE
TO
FOURTH
PINION
BEARING
JUNCTION OF MINUTE PINION STUD
AND MINUTE PINION
INTERSECTION OF
ROCKING BAR AND ~~=:::;!!!II"
SET LEVER
THIRD PINION
PIVOT
80.6
FOURTH PINION
PIVOT
FIGURE A
FIGURE B
The Model 80 movement should be
lubricated using only high grade
watch lubricants. The mainspring is
permanently lubricated with a solid
film
coating which is not affected
by normal cleaning solutions.
The mainspring should not require
lubrication.
Apply fine watch oil (Elgin M56b
oil is used in the factory) to the
pivots, pinions and other in bear-
ing surfaces in the movement
as
noted on Figure A (Front view) and
Figure B (Rear view). The watch oil
should be
put on the working sur-
faces
of two full escape wheel
teeth.