Battery Compartment
Maintenance and Setup
1. Place the unit on a level surface away from direct sunlight or
sources of excessive heat.
2.
Protect your furniture when placing the unit on natural wood
or wood with a lacquered finish. A cloth or other protective
material should be placed between the unit and the furniture.
3. Clean the casing with a soft cloth moistened only with mild
soap and water. Stronger cleaning agents, such as thinner,
benzine, or similar materials are not recommended, as they
may damage the surface of the case.
4. If the unit is not to be used for a prolonged period, such as
a month or longer, remove the batteries to prevent possible
corrosion. Should the battery compartment become corroded
or dirty, clean the compartment thoroughly and replace all
the batteries.
Power Sources
Note: This alarm clock radio operates on two power sources:
one “AA” battery (included) for the clock, and AC power
for the radio and backlight. The clock and an alarm will
operate with only the battery. For full operation of all
features, both power sources must be in use.
1. Please see A Consumer Guide to Product Safety, specifically
the Polarization and Power-Supply Cord Protection notes,
for instructions on plugging in the AC Power Cord.
To Replace the Battery
1. Open battery compartment cover.
2. Install 1 “AA” battery, making sure
that the polarity is correct as shown
within the battery compartment.
3. Close the battery compartment
cover and latch securely.
To Next Page
Loading...
Need help?
General
