Timotion TDH13P User Manual

Hand Control Programming- TDH13P
Version 4 August 2021
8 of 10
8
6. Presetting the Desk Starting Height
(1) Press button until the desk reaches its lowest position and then release button. Re-press button
again for 5 seconds and the digital display will flash for 10 seconds.
(2) Adjust the starting height number with the + or - button.
(3) After 10 seconds, the display will stop flashing and this will confirm that you have successfully set the
starting height.
7. Switching Metric and Imperial Unit
(1) Press memory buttons 1, 2 and 4 for 5 seconds.
(2) The digital display will show “C-I”. If no further instruction is input within 5 seconds, the system reverts to
the normal operation mode.
 How to choose a metric unit
Press button 2, the digital display will show “C” to stand for centimeter.
 How to choose an imperial unit
Press button 3, the digital display will show “I” to stand for inch.

Timotion TDH13P Specifications

General

Brand	Timotion
Model	TDH13P
Category	Controller
Language	English