EN
11
Operation
Preparing for Use
Before rst use, please charge the appliance for 4-5 hours (refer to “Charging Instructions” for details).
* Based on results from Tineco lab tests. Lab temperature 39.2°F (4°C) ~ 104°F (40°C).
Tips (SUCTION mode not available) :
• Solution mode/ Water Only mode:
Appliance starts with Solution mode by
default. Power on while the appliance is
upright, long-press for 3s to switch
between the two modes.
• Switch to Water Only mode:
LED Loop: Red
→
Blue (use water only)
• Switch to Solution mode:
LED Loop: Blue
→
Red (use cleaning solution)
Press the
button and the appliance will start in
AUTO mode by default. Press it again to turn off
the appliance. Switch between AUTO, MAX and
SUCTION modes by pressing the
button.
<142°
The appliance will stop working when put upright
and start running again when reclined.
* Do not recline more than 142° to avoid water
leakage.
Place the appliance on the charging dock
vertically after use for recharge and storage.
Note:
• Selecting the appropriate mode depending on the CWT contents is vital for maximum dirt detection
effectiveness.
• Do not vacuum foamed liquid.
• To vacuum water left on the surface, the appliance will keep running for 3 seconds after power off.
• Suction mode is only available in selected models, please refer to the actual product.
Stop Working Start Again
To Next Page
Loading...
Need help?
General
