What to do if the dirty water tank is full in my Tineco Washer?
If the Dirty Water Tank (DWT) in your Tineco Washer is full, it means the dirty water has reached the MAX line. To resolve this, empty the dirty water and then reinstall the DWT.
What to do if the clean water tank is empty on my Tineco FLOOR ONE S6 PRO?
If the Clean Water Tank (CWT) is empty in your Tineco Washer, you will see an animation and hear a voice prompt. Refill the CWT with water and cleaning solution to continue using the appliance.
Why does my Tineco FLOOR ONE S6 PRO Washer say low battery?
If your Tineco Washer displays a low battery warning, it means the battery is low. You should charge the appliance or try restarting it.
Why is the suction weak on my Tineco FLOOR ONE S6 PRO?
If you notice weak suction in your Tineco Washer, it might be because the dry filter is not installed, or it's dirty. Install the dry filter, or clean it and allow it to dry completely before reinstalling.
What does it mean when the LED loop illuminates red on my Tineco Washer?
If the LED loop on your Tineco Washer illuminates red and prompts you to begin a self-cleaning cycle, it indicates a dirt sensor malfunction or blockage. Remove any blockages, clean the debris channel, or restart the appliance.
Why are all the lights off on my Tineco FLOOR ONE S6 PRO?
If all the lights are off during the operation of your Tineco Washer, it suggests the battery may be overheating or malfunctioning. Allow the appliance to cool down and then restart it.
Comprehensive safety guidelines and warnings for using the appliance to prevent injury or damage.
Table listing product specifications like voltage, power, capacity, and waterproof rating.
Initial charging instructions and how to start the appliance in AUTO mode.
Explanation of AUTO, MAX, ULTRA, and SUCTION modes and their usage.
Instructions on how to remove, fill, and reinsert the clean water tank with water and solution.
Instructions for cleaning the main body of the appliance and addressing the red LED indicator.
Steps for emptying and cleaning the dirty water tank and its lid.
How to initiate and complete the self-cleaning cycle for the brush roller.
Guide on removing, cleaning, drying, and reinstalling the brush roller for peak performance.
A table listing common problems, their possible causes, and recommended solutions for the floor washer.
General| Model | FLOOR ONE S6 PRO Series |
|---|---|
| Battery Type | Lithium-ion |
| Battery Voltage | 25.2V |
| Battery Capacity | 4000mAh |
| Run Time | up to 35 minutes |
| Charging Time | 4 hours |
| Self-Cleaning | Yes |
| Display | LED Display |
| Smart Features | App Connectivity |
| Filtration System | HEPA Filtration |
| Product Type | Cordless Wet/Dry Vacuum Cleaner |
| Accessories | Cleaning Brush |
To Next Page