EN
16
Maintenance
Note:
• For optimal performance and to prevent odors, always clean and dry DWT, lters, brush roller, brush
roller cover completely after each use.
• Please make sure each part is installed correctly or the appliance may not work properly.
• Do not soak the appliance or wash it under water.
• Some water may remain in the appliance due to factory inspection.
• After maintenance, place the appliance on the charging base vertically. Do not expose the appliance
to direct sunlight, and store it indoors in a dry place.
Main Body
To reduce the risk of injury, switch off before
performing maintenance.
Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Solid red light
When LCD loop illuminates red, remove Dirty
Water Tank, clean the dirt sensor with a damp
cloth or the cleaning tool.
To Next Page
Loading...
Need help?
General
