Tiny Audio C5 - Connecting to Car Stereo via FM Transmission

Side7
2. Connectyourcaraudiostereospeaker“Aux‐in”or“Line‐in”tothe
“LINEOUT”jackatthebottomofTINYAUDIOC5withtheprovided
3.5mmaudiocable.

Remark:In“LineOut”mode,therewillbenoFMtransmissiontothe
carstereo.

ConnectingtheTinyAudioC5toyourcarstereousingFM‐transmission

‐‐SelectFMTransmittingFrequency(AutoMode):

1. Pressandhold“MENU”buttontoentermenumode,use“ROTARY
ENCODER”tosearchfor“AudioOut”and“FMTransmitterOut”and
confirmbypressing“ROTARYENCODER”againtoexitmenu.

2. Shortpress“FREQ/SF”buttontoshowFMtransmittingfrequency
(TXFREQ)andthenlongpressfor3secondstoactivatethe
automaticscanningofa“vacant”FMtransmissionfrequency
withoutinterferencewithotherchannels.Thescanningprocesswill
take20‐30secondstoscanthefrequencyautomaticallywitha
flashingdisplayof“‐‐‐.‐MHZ”andstopata“vacant”frequency.

3. Aftera“vacant”frequencyisfound,press“ROTARYENCODER”
buttonagaintoconfirmandexitsettingoritwillautomatically
confirmandexitthesettingafter3seconds.Theselected“vacant”
frequency(TXFREQ)willbeshownatthetopofthebluebar,e.g.
TX108.0MHz

4. ThentuneyourcarFMradiosystemtomatchtheselected“vacant”
frequency(TXFREQ)fortransmissionoftheaudiosignalfromTINY
AUDIOC5toyourcarstereoaudiosystem.


‐‐SelectFMTransmittingFrequency(ManualMode):
