MQTT Client
MQTT protocol pis designed primarily to exchange data between devices on the Internet
of Things and servers and client devices such as smartphones.
The main advantage is to keep the connection in both directions, making it possible to
control a simple Lan Controller located on the local network with the phone being in the
local network operator.
1. In this eld, we give the parameters used to connect to our server and authentication.
Mqtt services can take place without authentication, for example, a local area network.
The Your device number is a unique number that is part of the MAC-address. We serve it
with the recording equipment in the service mqtt.ats.pl. In response, we charge a unique
prex associated with the device and our account.
Prex is a unique feature for a class of devices, the devices themselves or the same sensors.
Time is a parameter in seconds, at which time the data are to be sent and stored in the
database. We recommend setting 300 seconds or more..
Parameter - Ping Time - determines the refresh rate of the connection broker mqtt. The
default value is 60 seconds.
2. In this eld you select, the readings are input / output to be sent to the server.
Then conrm the selection by pressing the "Save".
The service mqtt.ats.pl is based on open source broker Mosquito.
To use the service mqtt.ats.pl, you must rst register on the website:
mqtt.ats.pl/register/
Once activated by the administrator and received an email conrmation, you can use
service. The service is free for up to 5 registered devices.
1
2
To Next Page
Loading...