18
SYSTEM SETUP
Wireless Pairing of Devices
To pair the TEVO wireless thermostat to the wireless wiring centre, the thermostat should be fitted with batteries and in a
position to start the pairing process.
Step 1: At the TEVO wireless wiring centre press the pairing button (SW2) for 8 seconds to enter standby pairing mode.
Channel 1 LED will turn red. Short press SW2 to cycle through the channels to select corresponding loops for thermostat
zone.
Step 2: At the TEVO wireless thermostat, power off the device and then press both the power and clock buttons for 7
seconds. The thermostat LCD display will display the zone it is paired with if registered successfully.
Step 3: The LED on the TEVO wireless wiring centre will flash for 3 seconds to confirm that the device is paired and then
cycle to the next channel. The wiring centre will revert to normal operation after 2 minutes of inactivity.
Step 4: Repeat the process for all thermostats.
To Next Page
Loading...