Titan 50SPREAD - Helpful Hints; Remove and Identify Loose Parts

2
2. Remove and identify loose parts from carton and bag.
1. HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
WHEN ALL ELSE FAILS, READ THE DIRECTIONS AGAIN
 If your spreader does not spread evenly, be sure the FRONT on the gear box points to
the front of the spreader. The impeller must turn clockwise. Reversing the gear box will
cause the impeller to turn counter clockwise. Clean the impeller plate after each use.
Fertilizer stuck on the impeller blades will cause uneven spreading.
 Your spreader is designed to be pushed at three miles per hour, which is a brisk walking
speed. Slower or faster speeds will change the spread patterns. Wet fertilizer will also
change the spread pattern and flow rate. Clean your spreader thoroughly after each
use. Wash between the shut off plate and bottom of the hopper.
 Gears are permanently lubricated at the factory. Do not open the gear box or dirt may
enter.
#20 Wheel Assembly
Frame
2PCS
#23 Upper Handle
2PCS
#26 Handle Shaft
1PC
#30 Frame
1PC
#25 Control Rod A
1PC
#45 Cross
Brace
1PC
#49
Rain
Cover
#42 Impeller
1PC
#36 Wheel
1PC
#16 Hopper
1PC
#39 Gear Box &
Axle Assembly
1PC
#19 Pivot &
Bracket
1PC
#4 Gauge &
Lever
Assembly
1PC
#31 Frame Brace
1PC
#14 Screen
1PC